We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Get mass properties of cross section › Reply To: Get mass properties of cross section

August 26, 2024 at 4:02 pm
dlooman
Ansys Employee

Perhaps you could create remote points at the center of the cross-section at 1 meter intervals and then make the dof of the remote point master dof of a static (non-cms) superelement. Â