We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Volume Fraction too Low. How to Improve? › Reply To: Volume Fraction too Low. How to Improve?

August 21, 2024 at 8:35 am
Rob
Forum Moderator

It's a transient model, and looking at the Flux curve it's not levelled off yet. If you also monitor phase mass/fraction on the surface how does it look? Note LOOK, there are contour & vector plots available in Fluent for a reason; we typically use a mix of numerical, xy plot and images to figure out what's going on in the model.Â