We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Discovery entered multiple selection with single boundary condition › Reply To: Discovery entered multiple selection with single boundary condition

August 20, 2024 at 10:51 am
Atharv Joshi
Forum Moderator

Hi Mehmet,

Thanks for sharing this image. These all cylinders have individual flow paths with no single outlet. 

Its not possible to apply single input boundary condition on such surfaces. 

Thanks and Regards
AtharvÂ