We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Discuss Simulation General Mechanical Assistance Needed with Radius/Thickness Ratio Issue in ACP Pre Reply To: Assistance Needed with Radius/Thickness Ratio Issue in ACP Pre

Ashish Khemka
Forum Moderator

Hello,

Please see if the following forum thread helps: Element radius/thickness ratio warnings during solution? (ansys.com)

Regards,

Ashish Khemka