We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Assistance Needed with Transient Thermal-Electric Conduction Simulation in ANSYS › Reply To: Assistance Needed with Transient Thermal-Electric Conduction Simulation in ANSYS

August 17, 2024 at 4:12 am
jdidd1
Subscriber

Electrothermal Simulation of a Fuse: Temperature problem 

based on this post I came across, where I set the initial temperature to 48°C. However, the results I'm getting show a temperature range of only 48°C to 49°C maximum. According to the expected outcome, the temperature should range from a minimum of 48°C to a maximum of 60°C.

Could you please assist me in identifying and resolving the issue? Any insights you can provide would be greatly appreciated.

Thank you for your support.