We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Thermal Cooling › Reply To: Thermal Cooling

August 15, 2024 at 8:58 am
Tim Dukes
Subscriber

Hi Subashni, 

Thanks for the response, yes I am aware of the transient thermal. It was weather you are able to set different boundary conditions such as different temperatures and see how the assembly cools. 

E.g the heat sink would start at 100c and the antenna would be 50c and I would like to see how this cools over 20 seconds. I don't believe this is possible but please correct me if I am wrong. 

Best Regards,

TiM Dukes