We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Discovery entered multiple selection with single boundary condition › Reply To: Discovery entered multiple selection with single boundary condition

August 9, 2024 at 5:19 pm
mehmet.yoladi
Subscriber

I selected 50 surfaces from the power selection section. I had to enter the inlet with the same value one by one. Finally, the solve option opened. Unfortunately, I could not define 50 surfaces at once with a single inlet value.