Thanks for your suggestions, Rob. One more question: how do I show the room frame like the picture shown below? Since I "draw mesh" in Fluent and only enabled "edge", it showed some random lines on the wall of the room model (shown in the pic I attached to this post), how do I eliminate those random lines and just keep the room frame?
An AI-based virtual assistant for active Ansys Academic Customers. Please login using your university issued email address.
Hey there, you are quite inquisitive! You have hit your hourly question limit. Please retry after '10' minutes. For questions, please reach out to ansyslearn@ansys.com.
RETRY
You are navigating away from the AIS Discovery experience