We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Additive Print: Minimum Support Height › Reply To: Additive Print: Minimum Support Height

August 1, 2024 at 1:51 pm
Ashish Khemka
Forum Moderator

Hello, I am not an expert in this area but please see if the following article is relevant: In Additive Print Product, are there any instructions for simulating parts attached to the baseplate with minimum support height=zero? - Ansys Knowledge

Regards,

Ashish Khemka