We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Discuss Simulation Fluids Surface injection vs plain orifice atomizer Reply To: Surface injection vs plain orifice atomizer

Zwernjayden
Subscriber

I'm going to assume plain oriface then because I am more concerned about uniform mixing and combustion. If my fuel and oxidizer are both injected using dpm, do I need a traditional pressure or mass flow inlet? Or does the injection take its place?