We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Preprocessing › How to improve mesh quality for wing analysis › Reply To: How to improve mesh quality for wing analysis

July 23, 2024 at 2:47 pm
Rob
Forum Moderator

For tets I'd focus on Skew and not Ortho Quality. Both are valid, but I'd tend to leave Ortho for poly cells. 

Re the mesh (as opposed to cell) quality. Reduce the growth rate(s) and also review any surface mesh sizes. Check the inflation settings as the jump from inflation to first tet is a little large. 

Â