We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › How to create Lumped RLC in HFSS to match Circuit? (Simulate load as Lumped RLC) › Reply To: How to create Lumped RLC in HFSS to match Circuit? (Simulate load as Lumped RLC)

July 20, 2024 at 12:38 am
Stefano R
Subscriber

I even tried replacing the lumped RLC boundary with a Lumped Port with Z = 1/(1/R + i w C) and deleting everything after the lumped port. I still am not getting good results. How would you go about simulating a lumped RLC component as shown?

  Â