We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Installation and Licensing › Ansys Products › Poor quality mesh at trailing edge for 3d wing › Reply To: Poor quality mesh at trailing edge for 3d wing

July 18, 2024 at 7:57 pm
Purnima Janjanam
Subscriber

1. These are the sizings I used. All sizing are hard. Can you suggest any changes here.

2. The oscillations for this mesh look like this. Do you think these are going to oscillate forever? I expect the flow to oscillate for this design. So can I conclude by saying these are the results for this design? 

3. The results below are for another design. These oscillate at 3e^-5 (different from the other where they oscillate at 1e^-3). My converging conditions are 1e^-6. Do you think these will converge if mesh is more fine or will they also oscillate like the previous one?

4. Can you give me a breif idea about how to plot monitor points?