We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Named selection for edges are not being passed from one analysis to the next › Reply To: Named selection for edges are not being passed from one analysis to the next

July 16, 2024 at 10:05 pm
J.T.
Subscriber

 

Thank you, that clears up why it wasn’t transfering over. The creation of a nodal name selection using this method workes for a single design point. I haven't been able to effectively test this on multiple design points but it seems like it should work there as well.