We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Spilt a single domain into two parts and mesh them defrently fluent problem › Reply To: Spilt a single domain into two parts and mesh them defrently fluent problem

May 29, 2024 at 6:24 pm
Federico
Ansys Employee

In Fluent, you will need to create mesh interfaces between your different zones.

Go to Domain > Mesh > Interface and select the corresponding wall zones to create these interfaces. Fluent will then automatically set fluid-to-fluid boundaries as type interior.