We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › ansys additive microstructure simulation › Reply To: ansys additive microstructure simulation

May 21, 2024 at 5:50 am
Ashish Khemka
Forum Moderator

Hi,

Grain orientation in Ansys Additive is measured using Microstructure Simulation, which can provide insights into the grain orientation in the part produced using different process parameters such as laser power, speed, scan pattern, hatch spacing, powder layer thickness, etc. 

https://ansyshelp.ansys.com/Views/Secured/corp/v232/en/add_print/add_print_as2dm_mech_props.html

 

In addition, please refer to the following forum thread: microstrcture solver in ansys additive science

Regards,

Ashish Khemka