We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Default Mesh Size › Reply To: Default Mesh Size

May 17, 2024 at 2:15 pm
SB
Subscriber

Thank you for your reply.

I am not sure what I did, but the element size is also displayed next to default.  I cannot recreate this on a new WB session though; it would ony show Default.