We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Installation and Licensing › Ansys Free Student Software › Ansys 2023 – Material Designer – “MAPDL error” › Reply To: Ansys 2023 – Material Designer – “MAPDL error”

May 10, 2024 at 5:21 pm
Yingnan Wang
Subscriber

Hello Ashish and Mike,

Thanks a lot for your reply. Actually, I tried to use the Static structure function instead of the Material Designer to do modeling for the sample, it didn't give any error. 

But the issue is that I have three phases for my composites, i.e., matrix, fiber and particles, when mesh the geometry, the nodes among  the three phase are not matched. 

FYI, I tried use the spaceclaim share topology function for the three phases geometry, but it showed "Bodies failed to share topology. Transferring without shared topology." when I opened the "model. 

By the way, I am a student in the university, can we continue the talk here or shall I open a new post? 

 

Thanks for your help! 

Regards!

Yingnan