We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Why the sticking zone is not shown in the contact patch ? › Reply To: Why the sticking zone is not shown in the contact patch ?

May 10, 2024 at 2:12 pm
mrife
Ansys Employee

Hi Hajar

Double check the contact real constants; perhaps the limit frictional stress or contact cohesion values are not set as you intended.  Mike