We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Calculation Slot Fill Factor › Reply To: Calculation Slot Fill Factor

May 9, 2024 at 2:30 am
Reshmi Raghavan
Ansys Employee

Hello Andreas,

The slot fill factor is calcualted as . RMxprt assumes that the coils are placed one above the other and one beside the same as shown i the below figure.

 

So the total area of the coil can be considered as = 17*11*0.965*0.965/299.188 =58.2038percent