Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Updating Geometry of a Vehicle Model for Iterative Design/DOE Testing › Reply To: Updating Geometry of a Vehicle Model for Iterative Design/DOE Testing
May 3, 2024 at 1:53 pm
Ansys Employee
Hi Enayaat,Â
we have a tutorial on how do conduct such a parametric analysis via Workbench for Fluent: Chapter 2: Parametric Analysis in Ansys Workbench Using Ansys Fluent
The example creates the geometric parameters in DirectModeler but you can do the same in SpaceClaim: Driving Dimensions and Named Selections (ansys.com)
Finally, we have a course where we show how to do this entire within Discovery, looking at the rear wing of a formula car: Drag Reduction System - ANSYS Innovation Courses