Ansys Learning Forum › Forums › Installation and Licensing › Ansys Products › corrupted double-linked list – bad termination › Reply To: corrupted double-linked list – bad termination
May 3, 2024 at 9:03 am
Rob
Forum Moderator
Read the mesh into Fluent Meshing (same launcher, use Meshing mode) and check the quality in Display>Plot>Cell Distribution Assuming it's a tet/hex hybrid mesh look at skew and aspect ratio. Fluent Meshing doesn't have any of the solver functions so tends not to fail if the mesh is corrupt.
Where did the artery geometry and overall mesh come from?