Ansys Learning Forum › Forums › Discuss Simulation › LS Dyna › How to measure strain and stress in a coordinate system along the material axis › Reply To: How to measure strain and stress in a coordinate system along the material axis
May 1, 2024 at 11:08 am
Subscriber
Create a Cylindrical Coordinate System with the origin at the center of the cylinder and the Z axis along the axis of the cylinder. Plot Normal Stress or Strain and set the coordinate system to the Cylindrical Coordinate System. The X axis is Radial and the Y axis is Tangential so I suggest you relabel your figure to match how Ansys reports the stress components in a cylindrical coordinate system.