We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › How to get instersection Points made by two line bodies going through each other › Reply To: How to get instersection Points made by two line bodies going through each other

April 29, 2024 at 1:21 pm
Suhi Suhaas
Subscriber

My project is actually on a lattice tower.

 

I have a detailed plan of the lattice and I just went on to create line bodies based on that drawing. I could able to create X-Bracings using various points and projection of points depending on the requirement. 



As you can see in this image, I didn't have to do anything to get that point. It was just there when I created those line bodies going through each. But I just dont why those points were not created at all at many other locations. Am I missing something?