We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › The solver engine was unable to converge on a solution for the nonlinear problem › Reply To: The solver engine was unable to converge on a solution for the nonlinear problem

April 24, 2024 at 12:15 pm
Erik Kostson
Ansys Employee

 

Hi

See in the thermal analysis that fails, the solver output information (Losunginfo.).

https://www.padtinc.com/2012/07/12/solution-information-monitoring-your-solves-in-ansys-mechanical/

Check there for all errors and warning messages also.

All the best

Erik

Â