We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Unable to Sample Trajectories › Reply To: Unable to Sample Trajectories

April 23, 2024 at 1:04 pm
Saima Bukhat Khan
Subscriber

So I have tried by just selecting the outlet boundary, without selecting plane and start it and than stop, and than histogram and again it shows these line, without histogram. The file for the sample is written in .dpm format and than it shows this values in consule as well 

for diameter

total number = 1e-20

mean = 0

min = 1e+10

max = -1e+10

sum = 0

standard deviation = 0

Â