We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Reluctance Force Calculation in an Electro-Permanent Magnetic Clamp › Reply To: Reluctance Force Calculation in an Electro-Permanent Magnetic Clamp

April 19, 2024 at 7:26 pm
JUNAED HOSSAIN
Subscriber

Thanks for the feedback. I assigned force on the workpiece only. But still getting a very small force value (9.93 uN where my expectation is around 1-6 kN). I am doing magnetostatic simulation and current value 20 Amps and number of turns 100. I am attching the screen shot of materal used also. I am wondering if the process is correct to calculate the reluctance force on the workpiece.

Â