We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Discuss Simulation Fluids Separating cell zone for dynamic mesh Reply To: Separating cell zone for dynamic mesh

Midjan Jusic
Subscriber

Hello, I tried that. If I open Fluent, the cylinder gets automatically splitted.

Here is my configuration in the mesher:

 

And here what is happening when I load it in Fluent:

Cylinder was automatically splitted in cylinder-up and cylinder-down. I cant combine them anymore:

 

How can I separate the two faces but still keep my cylinder walls as one position?

Thank you.