We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Cycle to cycle simulation (multi-cycle) in ANSYS-forte › Reply To: Cycle to cycle simulation (multi-cycle) in ANSYS-forte

April 15, 2024 at 9:27 pm
Fethi
Subscriber

But I have spray injection for each cycle. Considering 15 cycles engine run. It means I need to specify 15 times injection timing. Do you think this is the unique method I have to follow ??