We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › MESH FOR HELICAL STRAKE › Reply To: MESH FOR HELICAL STRAKE

April 10, 2024 at 9:21 pm
kingdsystems
Subscriber

Thanks Rob for your prompt response. 

The inlet velocity for each of the structure was taken to be 0.021m/s.

Below are the mesh for each of the structures.

SMOOTH STRUCTURE

CACTUS SHAPED STRUCTURE

HORN-STRAKED STRUCTURE

HELICAL-STRAKE

Please, if my meshes are wrong, can you help with best way to go about doing a good mesh.

 

Thanks