We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Problems with dynamic mesh settings while mesh motion › Reply To: Problems with dynamic mesh settings while mesh motion

April 10, 2024 at 1:38 pm
Federico
Ansys Employee

1) Do you have 2 different adjacent zones on either side of your cylinder? If so, make sure you define a cell height for both sides. In the picture I shared, there was only 1 adjacent zone.