We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Installation and Licensing Ansys Products Ansys mechnical – Named selection through worksheet Reply To: Ansys mechnical – Named selection through worksheet

Ashish Khemka
Forum Moderator

Hi Kavi,

Let Named selection select the faces at x value 5.2425m. After this add another filter to select the faces based on y or z location. You may find the following link to be helpful: Beyond Clicking: Named Selections Move to the Worksheet - PADT (padtinc.com)

Regards,

Ashish Khemka