We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Installation and Licensing › Ansys Free Student Software › Gyroid representative volume element (REV) periodic boundary setup › Reply To: Gyroid representative volume element (REV) periodic boundary setup

April 5, 2024 at 10:03 am
Rob
Forum Moderator

It's possible to link the boundaries via UDF or similar, but looking at the image the periodic section is in the 85mm length direction. If that is the case what's flowing/conducting in that direction? 

I'm only permitted to offer general comments on here as it's a public forum.Â