We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Mesh adaption of cells that are not being marked › Reply To: Mesh adaption of cells that are not being marked

March 25, 2024 at 4:12 pm
vedama
Subscriber

I do not have a coarsening criterion currently.

I'm trying to understand your point about holes just so I can get a better understanding of the functionality. My current register looks for density gradients/curvatures in the solution and marks cells for adaption based on a specific set of minimum threshold values. If the cell values are above this threshold value, they should adapt. If the cell values are lower as stated/shown by the marked cells, what exactly is happening to cause the cell to be adapted?