We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Shared topology and Hex mesh › Reply To: Shared topology and Hex mesh

March 20, 2024 at 8:57 pm
peteroznewman
Subscriber

Shared topology can create imprints on the faces of six-sided blocks that prevent the block from being sweepable, but you can still get a full hex mesh by using a Multizone mesh method.  Shared topology is preferred over bonded contact.