We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Moment of inertia and Centre of Gravity › Reply To: Moment of inertia and Centre of Gravity

March 19, 2024 at 2:56 pm
deepesh.p.gurdasani
Subscriber

Thanks for the video link but to check overall C.G and M.O.I I will have to run a dummy analysis iteratively which could be time consuming, isn't it?

1) After creating multi body part, would'nt the mesh get messed up? because isnt it mainly used for getting conformal mesh similar to share topology?

2) Here actually I am not talking about splitting a single component and then moving the splitted parts into new component (which would eventually create multi body part. Here I am talking about totally two or more different parts where I want to check overall C.G and M.O.I.

 

Please correct me if I am wrong.

 

Thanks