We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Validation of force from Transient 3D Maxwell simulation › Reply To: Validation of force from Transient 3D Maxwell simulation

March 18, 2024 at 5:44 am
Anunda Chuenlerssakul
Subscriber

I have seen that many tutorial, also official tutorial of ansys doesn't care that much about the meshing in case if magnetostatic. So, if it poosible for me to neglect all mesh at the air gap and just provide the mesh at surface of material that I would like to observe the force and torque?