We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Discuss Simulation General Mechanical Thermo-structural failure analysis Reply To: Thermo-structural failure analysis

sachin.kumar
Subscriber

Pl correct me if i am worng, As I understood firstly run full  model at coarse mesh to generate the boundary condition at the cut section face or edge

in this strategy issue is to run full model to get the displacement at the cut interfaces and my model is too big to simulate even with coarse mesh.

but i will implement this strategy in radial direction.

let me know if you have any more suggestion