We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Holes in mesh › Reply To: Holes in mesh

March 14, 2024 at 8:59 am
Johanna Hjeltström
Subscriber

Fluent meshing is not allowing me to perform a surface mesh quality check. The volume mesh quality is quite good in my eyes though, average orthogonality: 0.95, average skewness: 0.047 and average aspect ratio is 3.2.

I attach a picture of the mesh check because I don´t really know what it tells me.

Â