We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Discuss Simulation Electronics Variation of outputs from MotorCAD to Maxwell Reply To: Variation of outputs from MotorCAD to Maxwell

Vidyabharati Ippili
Subscriber

I am trying to simulate 3phase induction motor in MotorCAD. I am getting phase current as 360 Amp in MotorCAD. 

But when i am exporting it to Maxwell 2D, I am getting the phase current as 422Amp. Because of this variation in current, all the output parameters are changing. I got Torque as 6995 Nm in MotorCAD whereas in Maxwell it is coming around 7990Nm. The losses are having a big difference too.