We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Discuss Simulation Fluids Problems in selecting combustion parameters for pulverized coal Reply To: Problems in selecting combustion parameters for pulverized coal

Vijay Narayan
Ansys Employee

Hi Stemphanie, I didnt fully understand your requirement. Since you mentioned that a mesh indepedence study is done - my understanding is you have completed the combustion simulation for different meshes and the results are consistent now and doesnt vary with mesh. 

What is meant by equation parameter selection ? Could you elaborate a bit more on this, so that I could give necessary guidance.

 

Regards,

Vijay