We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › named groups not coming into fluent › Reply To: named groups not coming into fluent

March 8, 2024 at 4:56 pm
Andrew Hayes
Subscriber

 

I just have a body surface, and the enclosure that was created in SpaceClaim.  I created groups for the entrance/exit/air(remaining sides of enclosure)/body.  If I highlite the specific named group in SpaceClaim, only that face lights up.  The surface mesh above that worked was quick to show that it worked.  I didn't take the time to make it appropriate for the analysis.  I have tried renaming the groups etc, but I just can't get it to come into Fluent.  I am sure it is something stupid, but I can't figure it out.

 

Â