We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How to see Convergence of results in ANSYS Mechanical APDL › Reply To: How to see Convergence of results in ANSYS Mechanical APDL

March 6, 2024 at 3:02 pm
dlooman
Ansys Employee

You would have to open the APDL gui in a separate Ansys session.  

Is solve.out perhaps too big for an editor to open?  Perhaps you should just run the job for 10 or 20 secs to see what is going on.