We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › LS Dyna › Adjustment of stresses after calculation in LS-Dyna › Reply To: Adjustment of stresses after calculation in LS-Dyna

March 4, 2024 at 3:37 pm
igandiko
Ansys Employee

Hello, I don't think there is a way to rewrite binout/d3plot data with a stress cutoff. Perhaps you can either make the analysis stable or reduce termination time if the singularity occurs after a certain time. 

Please take a look at *FATIGUE_LOADSTEP. LS-DYNA performs a fatigue calculation only for the stress / strain history extracted between TSTART and TEND defined in this card.

Note that *FATIGUE_ELOUT can be used to calculate fatigue results of a few elements in the model instead of the full model.Â