We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Rayleigh taylor in fluent › Reply To: Rayleigh taylor in fluent

February 1, 2024 at 8:59 am
khush.bakhat.rana
Subscriber

I added symmetry and walls while meshing. Is this enough or do I have to do something in the setup also. I am new to Fluent don't know alot.

I have added symmetry and walls while meshing (please see picture attached). but did not say anything about the Bounday conditions in the fluent setup. Is this enough or do I need anything else?

Â