We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Scoping boundary condition to ‘Point mass’ › Reply To: Scoping boundary condition to ‘Point mass’

January 24, 2024 at 7:03 pm
deepesh.p.gurdasani
Subscriber

1 )Thanks for your answer sir. Also, is there any setting specified by ANSYS that allows for acceleration to be scoped to a point mass if density set to zero because I am unable to see acceleration's position getting changed to that of point mass. Just curious to know if it is a trial and error method or there is procedure for it given by ANSYS.

2) In APDL also, there is no direct way of scoping acceleration to a part or point mass ?

 

Thanks