We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › PSD Response – Which stress value is to be taken to compare the yield strength › Reply To: PSD Response – Which stress value is to be taken to compare the yield strength

January 24, 2024 at 2:34 pm
mdmech.mech
Subscriber

Thanks for the reply, sir. Hence, I should not take RMS values; I have to look for 3-Sigma stress that is 283.35 MPa. Please Confirm