Ansys Learning Forum › Forums › Discuss Simulation › Electronics › How to simulation no- load and full load PM generator › Reply To: How to simulation no- load and full load PM generator
December 4, 2023 at 5:34 am
phuonganhlovely.me
Subscriber
thank Harinath Vudumula,
- as i have mention my design will be run as 2 mode but the major one is generator. so at full load condition ( 60,000 rpm, 5Nm and resistance load) if I want to avchieve output line voltage 380V (380V is rms of line voltage), 48A, 30KW. I need to enter  Peak value of phase voltage in the equation (ex: Va= Vpeak*sin(2*pi*f*Time-delta) ) Vpeak = (380*sqrt(2)) / sqrt(3) =310V, is this correct?
thanks a lotÂ