We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How to call homemade routines in an UPF ? › Reply To: How to call homemade routines in an UPF ?

November 29, 2023 at 8:27 pm
Loïc Féréol
Subscriber

Hi ANSYS community,

I solved this problem a few weeks ago, it is possible to call homemade routines. The routines don't have to be linked via the GUI. You just have to call them in the main routine (e.g. UserMatTh.F). I recommand to test them outside of the simulation in a simple case.

Best,

Loïc Féréol