Ansys Learning Forum Forums Discuss Simulation LS Dyna Error Termination without specific error message Ls Dyna Reply To: Error Termination without specific error message Ls Dyna

Alex R.
Ansys Employee

Hi, 

Frequency of the database binary D3PLOTS are controlled by DT value in the card *DATABASE_BINARY_D3PLOT. Alternatevly, you can specify LCDT curve that specify the frequency of d3plots and IOOPT flag that governs how the plot state frequency is determined from curve LCDT.

Your simulation is terminating after 8.4837e-4, so changing the value of DT to 1E-5 or 1E-6 will give you at least 84 frames or 840 frames.

Regads,
AlexÂ